This page describes how to set up a M500 base station in a single-cell configuration.
In a single-cell configuration, only one M500 base station is used.
Connecting the M500 base station
Plug an Ethernet (network) cable into the RJ45 connector labeled “NET”, and plug the other end into the network side to establish a data link.
Configuring the M500 base station to single-cell mode
You can configure the base station via WebUI, Provisioning, or the LINK button.
Import the following setting value to to thebase station via provisioning.
For more information about this setting, see multicell.role.
LINK button on the base station
For the base station, follow the instructions described in How to set the base station operating mode or factory reset using the LINK button.