Content
- Please use at least EndPoint Manager 15.0.53 Stable version to have multi-cell functionality.
- All base stations have to be on the same firmware release.
- If you change a base station parameter on FreePBX side, you need to do an extension assignment to make this configuration effective.
Preconditions
- Brand Snom is created in the Endpoint Manager → Advanced → Add Brand
- M900 Template is created under Snom Brand via Snom → New Template
- Extensions have been created
- All base stations are on the same firmware level
Procedure for Primary base
- Login to FreePBX web user interface
- Go to Settings → Endpoint Manager
- Open the right panel as shown below
- Click on Base Station Management under Advanced menu
- Click Add Base Station
- Fill in the blanks with the required information/selection (Brand, Template, MAC address, IP address if peer to peer selected etc...)
- Click Save BaseStation
- Go to Endpoint → Extension Mapping
- Click Add Extension under Extension Mapping
- Select a predefined extension from the list
- Select Brand, Template, Model and the Base Station respectively
- Select Save and Rebuild Configs from the dropdown below and click Use Selected
- Repeat these steps for each extension that is planned to be added to the base
- Log in to the M900 WUI
- Under Management, put the provisioning server address as the configuration server address (where the config file is located on FreePBX side)
- Click Save and Reboot
- Click Multi-Cell menu
- A message appears that the base station is joined as Primary
Procedure for Secondary base(s)
- Login to WUI of M900 (No configuration on FreePBX required)
- Go to Country menu and align Country, Timeserver and Language informations with Primary
- Go To Multi-Cell menu and enable Multi Cell System and align System Chain ID with Primary
- Save and Reboot
- Click Multi-Cell menu
- A message appears as the base station is joined as Secondary
- Check if Extensions available on Secondary as well as Primary base station under Extension menu
- Check if Server information is available on Secondary as well as Primary base station under Servers menu