Content
You can enlarge all pictures by clicking on them!
In this article we will explain the steps necessary to connect your Fritzbox to the Internet before setting up a Snom device.
This article is based on a test on a FritzBox 7590 with Fritz OS version 7.20. It was tested on a Telekom All-IP connection.
The cables and adapters supplied with the FritzBox differ depending on the product variant.
Therefore, take the cabling according to the scope of delivery of your FritzBox as in one of the two following sections described above.
Plug the RJ45 plug of the DSL cable into the "DSL/TEL" socket of the FritzBox.
Plug the TAE plug of the DSL cable into the socket of the TAE socket labeled "F" (see Fig. 1).
Fritzbox 7590
Fritzbox 7390
Select "Telekom" in the combo box and click "Next". If "Telekom" cannot be selected, first select "Other Internet providers" and then "Telekom".
Enter the access data you have received from Telekom in the respective input fields and click "Next".
Activate the option "Check Internet connection after saving the settings" and click "Next".
Now the FritzBox establishes the Internet connection with the entered access data.
The setup is complete when the message "Internet connection verification successful" is displayed.
Afterwards you will find your access data under the menu item: Internet/Access data
Setting up Telekom SIP trunk (FritzBox)
The FRITZ! box supports only the operating mode "Registered Mode". The "Static Mode" is not supported.
To use this new feature (sip trunk) a lab version is currently required.
Now you can assign the phone numbers of your SIP trunk to telephones and other devices.
For direct configuration of a snom phone on any other router (without SIP registrar feature) on a telecom line they need a different configuration:
For a standard All-IP connection of the Telekom it is the following :
Further Information
Related articles