Content
The M5 Snom DECT repeater can be registered with any of the M-series base stations (M300, M700 and M900) using the base's web interface and following the procedure below. and in the same way it can be registered in a daisy-chain configuration with another M5 repeater (up to 3 repeaters can connect to the same base, either in single or multi cell mode)
Assign the repeater a name, and choose if you want to proceed with the automatic or manual mode
If you are doing this with the automatic procedure, just click on “Save”, the base station will send out a sync signal and register the repeater
You should now be able to see the registered repeater into the web interface, with all the info about the device
From the two drops down menus, select which RPN will be assigned to the repeater (avoid using the same RPN as another repeater) and to which base it will need to connect: the latter step is crucial when installing a repeater in a multicell system, or when installing it in an M5 daisy-chain
Once you choose the two RPNs, click on “Save”
You should now be able to see the registered repeater into the web interface, with all the info about the device
Further Information
Related articles