After upgrading the base to version 400B02 the provisioning via HTTPS/TLS isn't working anymore

M300 / M700 Issue

This is a known issue of firmware version 400B02. The base isn't sending the manufacturer certificate anymore.

For this reason, the client authentication based on TLS certificates cannot work.

Solution

The issue was fixed with version 400B03. Please upgrade to this or any later version to solve the problem.

• Page:
  Adding M5 repeaters in a multicell environment
• Page:
  After upgrading my DECT base to 400B02 my M65 cannot register anymore
• Page:
  After upgrading the base to version 400B02 the provisioning via HTTPS/TLS isn't working anymore
• Page:
  Assign a handset to a SIP account on a M300
• Page:
  Attended or blind call transfer of the 2nd call results in merging the 1st and 2nd incoming call
• Page:
  Can I daisy-chain M5 DECT repeaters
• Page:
  Can I install a mixed system with M700 and M900 together
• Page:
  Can I register a 3rd party DECT handset or repeater to a Snom M300,M700,M900 base station
• Page:
  Common faults on M-series DECT base stations: causes and solutions
• Page:
  DECT Solution FAQ
• Page:
  Difference between DECT and configuration synchronization
• Page:
  Do the M300,M700,M900 support GAP
• Page:
  Dropped connections and failed handset handovers in a DECT multi-cell
• Page:
  Dropped SIP registrations on DECT multicell
• Page:
  End of Support for the M700 on 3CX V18
• Page:
  How can I trigger a settings sync on a DECT M300,M700,M900
• Page:
  How to disinfect my DECT handset
• Page:
  How to factory reset an M10 KLE handset
• Page:
  How to factory reset an M15 SC handset
• Page:
  How to factory reset an M18 KLE handset