Snom Service Hub

Content

Page tree

Step by Step Guide:

  1. Isolate the PA1 from your Network and DHCP Server.

  2. Allow the PA1 to go through its boot process.

  3. Allow the power LED to flash for about a minute and then press the IP reset button to interrupt the DHCP process.

  4. The power LED will turn solid red and shortly after the call LED will turn solid green.

  5. Configure your PC with a static IP address of 192.168.0.3, Subnet mask of 255.255.255.0 and make the PA1 your Default Gateway address 192.168.0.2

  6. Open a Web Browser and connect to the PA1 at the default IP address 192.168.0.2

  7. If this procedure does not work than you are possibly using and older firmware version. Please update your PA1

  8. Run a limited DHCP Server on your laptop or connect to your Network and allow the PA1 to obtain and IP address.

  9. Upgrade the firmware to the latest firmware for the PA1

  10. You can use the Support tool SPLiT which can run a limited DHCP Server (SPLiT application can be downloaded here https://github.com/pbertera/SPLiT/releases )

Further Information


Related articles