Reboot your Snom Phone

If you want to reset the Snom Settings or want to trigger a new Provisioning it could be usefull to reboot your phone.

To reboot your Phone you have two Options:

1. Use the Key Combination: **##
   The Phone will reboot almost immediately
   
   

2. Enter your Snom WUI - Avanced/Update and than click on "Reboot".
   
   

• Page:
  Entering Snom Deskphone Web Interface - WUI
• Page:
  Get the snom phone ready for operation
• Page:
  How can I backup and restore the phone configuration
• Page:
  How can I configure a second hand Snom device that still points to the old PBX because of a redirection
• Page:
  How can I obtain a SIP trace from the phone
• Page:
  How to - Core Dump
• Page:
  How to capture large or permanent PCAP traces
• Page:
  How to enable early logs on desk phones
• Page:
  How to obtain a log from a desktop phone
• Page:
  How to obtain a SIP trace from a deskphone
• Page:
  How to setup a Syslog server on a Desktop phone
• Page:
  How to store a PCAP trace into an USB mass-storage device
• Page:
  How to store a phone syslog into an USB mass-storage device
• Page:
  How to store a SIP trace into an USB mass-storage device
• Page:
  Incoming calls are rejected by "403 Use Proxy"
• Page:
  Is my Snom phone still covered by warranty
• Page:
  My phone displays the SIP Disabled - error, how can I fix it
• Page:
  Reboot your Snom Phone
• Page:
  Setting up a Snom Deskphone
• Page:
  Setting up WLAN Connection on Snom Deskphone
• Page:
  Store HTTP-Trace on USB Stick
• Page:
  Store Pcap on USB Stick
• Page:
  Store SIP-Trace on USB Stick
• Page:
  Store Syslog on USB Stick
• Page:
  Troubleshooting How-to
• Page:
  What kind of DTMF types Snom phones support and how to change them
• Page:
  Why does my Snom phone always end the current call after a certain time